8 Stored Programming
334
Stored Programming
8
Note •Once a job is stored to a button, it cannot be overwritten.
• Select [ ] to return to the previous screen or [ ] to move to the next screen.
• Scroll the list by drag or flick operation to switch the screen to be displayed. For information on how
to drag or flick, refer to "Touch Screen" (P.76).
3 Set the feature you want to register.
Note •The machine sounds an audible tone while a stored program is being registered.
• Press the <Interrupt> button to cancel registration.
You can change the volume of the sound that notifies that a stored program is being registered. For information on the
settings, refer to "5 Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming Tone" in the Administrator
Guide.
4 Press the <Start> or <Clear All> button.
Note •An icon is displayed to the left of each registered stored program for Build Job.
• If no name is entered for a registered stored program, the name becomes “(No Name)”.
For information on how to name a registered stored program, refer to "Entering/Changing a Stored Program Name" (P.334).
Deleting Stored Programs
The following describes how to delete stored programs.
1 Select [Delete].
2 Select the number to be deleted.
Note •Select [ ] to return to the previous screen or [ ] to move to the next screen.
• Scroll the list by drag or flick operation to switch the screen to be displayed. For information on how
to drag or flick, refer to "Touch Screen" (P.76).
3 Select [Delete].
Delete
Deletes the stored program.
Note •Deleted stored programs cannot be restored.
Cancel
Cancels deleting the stored program.
Entering/Changing a Stored Program Name
The following describes how to enter or change the name of a stored program.
Up to 36 characters are allowed for a stored program's name.
For information on how to enter characters, refer to "Entering Text" (P.78).
To Next Page
Loading...
Need help?
General
