Fujitsu fi-6110 User Manual

Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
36
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
Conditions for Using the Carrier Sheet
■Paper size
The paper sizes that can be scanned are as follows:
z A3 (297 × 420 mm)
z B4 (257 × 364 mm)
z 11” × 17” (279.4 × 431.8 mm)
* The above paper sizes must be folded in half to be scanned.
■Paper quality
Paper type
Recommended paper type for scanning is as follows:
z Standard office paper
Paper weight
The following range is supported for paper weight:
z Up to 63.5 g/m
2
(17 lb)
Precautions
Take note of the following:
z You cannot mix the Carrier Sheet and regular documents in the same
batch for scanning.
z Up to three Carrier Sheets can be loaded at once.
z Depending on the amount of memory used by running applications,
there may be insufficient memory to scan a double-page spread
document with the Carrier Sheet in high resolution. In that case,
specify a lower resolution and try scanning again.
z Do not write on, color, stain, or cut the end with a black & white
pattern because the Carrier Sheet will not be recognized properly.
z Do not place the Carrier Sheet upside down. Otherwise, a paper jam
may occur and damage the Carrier Sheet and the document inside.
z Do not leave your document inside the Carrier Sheet for a long time.
Otherwise, the ink on the document may be transferred onto the
Carrier Sheet.
z To avoid deformation, do not use or leave the Carrier Sheet in high
temperature places such as under direct sunlight or near a heating
apparatus for a long time.
z Do not fold or pull the Carrier Sheet.
z Do not use a damaged Carrier Sheet because it may damage or
cause the scanner to malfunction.
z To avoid deformation, keep the Carrier Sheet on a flat surface without
any weight on it.
z Be careful not to cut your finger on the edge of the Carrier Sheet.
z If paper jams occur frequently, feed about 50 sheets of PPC paper
(recycled paper) before scanning with the Carrier Sheet.
The PPC paper (recycled paper) can either be blank or printed.

Fujitsu fi-6110 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	1024
Input color depth	24 bit
Maximum scan size	216 x 355.6 mm
Optical scanning resolution	600 x 600 DPI
Flatbed scan speed (b/w, A4)	3 sec/page
Scanner type	Sheet-fed scanner
Sensor type	CCD
ISO A-series sizes (A0...A9)	A4, A5, A6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	500 sheets
USB version	2.0
Standard interfaces	USB 2.0
Scan media weight	52 - 127 g/m²
Dimensions (WxDxH)	292 x 143 x 130 mm
Power requirements	100 - 240 V, 50/60 Hz
Image formats supported	JPG, TIF
Recommended media weight	80 g/m²
Compatible operating systems	Microsoft Windows 7 (32bit/64bit)/Vista (32bit/64bit), Windows Server 2003/2008/2008 R2 (32bit/64bit), Windows XP (32bit/64bit).
Power supply type	AC
Power consumption (standby)	5.36 W
Power consumption (typical)	28 W
Operating temperature (T-T)	42 - 95 °F
Operating relative humidity (H-H)	20 - 80 %
Bundled software	TWAIN, ISIS, ScandAll PRO, Adobe Acrobat, QuickScan Pro.

Weight and Dimensions

Depth	143 mm
Width	292 mm
Height	130 mm
Weight	3000 g