Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
78
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
Using a Button on the Scanner to Start Scanning
The [Scan/Stop] and [Send to] buttons on the operator panel
can be configured to perform scanning by simply pressing the
button.
To configure this setting, you first need to assign an
application to be launched for each button.
Computer setup
1 Confirm that the scanner is connected to your computer,
then power on the scanner.
For details, refer to “Connecting the Cables” in Getting Started.
2 Select the [Start] menu J [Control Panel].
D The [Control Panel] dialog box appears.
3 Click the [Hardware and Sound] icon.
D The [Hardware and Sound] dialog box appears.
4 Click the [Scanners and Cameras] icon.
D The [Scanners and Cameras] dialog box appears.
5 Display the properties of the scanner.
Double-click the scanner icon.
6 Click the [Events] tab and select an event.
From the [Select an event] drop-down list, select an event from which
you want to launch an application.
In this function, the following events can be selected:
z [Scan Button] (press the [Scan/Stop] button)
z [Send to 1] to [Send to 9] (press the [Send to] button while a
number from 1 to 9 is displayed on the Function Number
Display)
5.5 Customizing the Scanner Settings
To Next Page
Loading...
Need help?
General
Weight and Dimensions
