Fujitsu PRIMERGY RX4770 M6 User Manual

After replacing or upgrading LAN controllers
▶
You need to restore the configuration for the LAN T
eaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
For more information, see the relevant LAN driver manual.
After replacing a system board
The following procedure must be done for each system board that is
replaced.
▶
Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
▶
If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
For more information, see the relevant LAN driver manual.
5.3.18 Switching off the ID indicator
▶
Press the ID button on the front panel, or use the iRMC S5 web interface or
ServerView Operations Manager to switch of
f the ID indicator after the
maintenance task has been concluded successfully.
For more information, see "Locating the defective server" on page 97
or
the "ServerView Suite Local Service Concept (LSC)" and iRMC user
guides.
Using the ID button on the front panel
▶
Press the ID button on the front panel to switch off the ID indicators.
Basic software procedures
RX4770 M6 Upgrade and Maintenance Manual 113

Fujitsu PRIMERGY RX4770 M6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX4770 M6
Category	Server
Language	English