Fujitsu ScanSnap S500 User Manual

142
5.2 Troubleshooting Checklist
This section describes common problems that may occur during the usage of ScanSnap and how to
resolve them.
Before you request repair service, check the following list.
If you cannot solve the problem after checking the following list, contact an authorized FUJITSU
scanner service provider.
Symptom Check This Item Resolution
The scanner cannot be
turned on.
Is the AC/USB cable and
the AC adapter connected
correctly?
Correctly connect the AC/USB cable
and AC adapter.
Disconnect and then re-connect the
AC cable and AC adapter.
(* Wait at least 5 seconds before
reconnecting the AC cable)
Is the paper chute closed?
(The scanner’s power is
controlled by closing/open-
ing the paper chute.)
Open the paper chute.
Is Windows normally
started up?
(This scanner’s power is
controlled by turning on/off
the computer.)
Wait until Windows has started up
completely. LED will turn off
when Windows is starting up or in
the sleeping mode.
Did you push the [POWER]
button to turn off the scan-
ner? (The scanner can be
turned off by pressing
[POWER] button when the
paper chute is opened.)
Press the [POWER] button.

Fujitsu ScanSnap S500 Specifications

General

Film scanning	No
Color scanning	Yes
Input color depth	- bit
Maximum scan size	216 x 356 mm
Scanner type	Sheet-fed scanner
Sensor type	CCD
ISO A-series sizes (A0...A9)	A4, A5, A6
ISO B-series sizes (B0...B9)	B5, B6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	50 sheets
USB version	2.0
Standard interfaces	USB 2.0
Minimum system requirements	Windows 2000/ XP/ Vista
Scan media weight	52 - 127 g/m²
Power requirements	AC 100V - 240V, 50 / 60 Hz
Sustainability certificates	ENERGY STAR
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	RoHS

Weight and Dimensions

Weight	2700 g