EasyManuals Logo
Home>Fujitsu>Tablet>Stylistic ST5000 Series

Fujitsu Stylistic ST5000 Series User Manual

Fujitsu Stylistic ST5000 Series
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
3
Chapter 1
Stylistic ST5000 Tablet PC Features
This chapter provides an introduction to the Stylistic ST5000 Tablet PC system hardware and software and gives an
overview of some of the Tablet PC’s features. Detailed specifications on the features discussed in this chapter are
given in other chapters of this guide.
The Stylistic ST5000 computer series is designed for the Microsoft Windows XP Tablet PC Edition. The system uses
an active digitizer and conforms to the Windows Tablet PC standards.
The Stylistic ST5000 Tablet PC system has been tested by Windows Hardware Quality Labs (WHQL) at Microsoft
Corporation and is compliant with PC2001 system design guidelines.
Hardware Features 1
PC Card Support 1
The Stylistic ST5000 Tablet PC is equipped with a PC Card slot that allows you to install a Type I or II PC Card. The
PC Card slot is compliant with PC CardBus Standard Release 3.0 and provides support for the following PC Card
features:
Multivoltage 3.3/5 V PC Cards (detected automatically)
CardBus (PCI bridge) type PC Cards
Supports PCIC (PC Card I/O Card) protocol
Backward compatibility with previous PC Card Standard Release level PC Cards
Internal Modem 1
The Stylistic ST5000 Tablet PCs are equipped with an internal 56 Kbps* modem. (Note: The 56 Kbps rate is nominal;
due to FCC restrictions, actual rates are limited to 53 Kbps.)
For details on the built-in modem, see “Internal Modem Specifications” on page 34.
Internal LAN 1
The Stylistic ST5000 Tablet PCs are equipped with an internal wired 10/100/1000* Base-T/Tx Ethernet LAN.
*1000 Mbps, commonly referred to as Gigabit Ethernet.
ACPI Support 1
The Stylistic ST5000 Tablet PC supports the Advanced Configuration and Power Interface (ACPI) Specification,
revision 1.0, in all system configurations. With ACPI, power management features are controlled and configured
primarily by the BIOS and BIOS settings. The ACPI specifications allow for additional control over power
management features such as state transitions and device timeouts. Refer to the ACPI specifications and the
documentation for your operating system regarding power management with ACPI.
DMI Support 1
The Stylistic ST5000 supports the Distributed Management Interface (DMI). DMI provides a framework for managing
the variety of components within the tablet PC. The Event Logging menu in the BIOS allows you to configure the
DMI event logging options (see “Event Logging Submenu” on page 19).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu Stylistic ST5000 Series and is the answer not in the manual?

Fujitsu Stylistic ST5000 Series Specifications

General IconGeneral
BrandFujitsu
ModelStylistic ST5000 Series
CategoryTablet
LanguageEnglish

Related product manuals