3. TARGET TRACKING (TT)
3-15
3.11.3 How to assign a name to a TT
1. Referring to section 3.11.1, activate the preset name function.
2. Referring to section 3.10.2, show the target’s data in the data display area.
3. Place the cursor on the target data, then press the left button.
The [TARGET NAME] menu appears.
Preset names are listed below [3 PRESET LIST]. In the above example, the name
"TEST1" is set as a preset name.
4. Select a name from [3 PRESET LIST], or select [2 TARGET NAME] to assign a
different name to the target.
If you select [2 TARGET NAME], the software keyboard appears. Enter a name
for the target, then select [END].
The selected name (preset or manual input) appears at [2 TARGET NAME] and
is also applied to the on-screen target.
5. Close the menu.
Note 1: When a name is assigned to a target, the numerical on-screen indication is
replaced with the assigned name, as shown in the example figure below.
To view the named target’s TT number, show the target data in the data display area.
Note 2: The same name can be assigned to multiple targets.
TARGET NAME
1 BACK
2 TARGET NAME
3 PRESET LIST
TEST1
TEST1
To Next Page
Loading...
General
