109
<Model Menu (Common Functions)>
Maximum change near center by
center trim operation (Does not change at end of
the stick movement) When the adjustment range
(Range) value is made small, trim is active only
near the center.
Normal trim (linear) operation.
When the adjustment range value is decreased,
trim is active only near the center. Needle high
trim works as high trim based on the center. This
operation is similar to reverse ATL trim.
is used when the mixture is either too rich or
too lean, which can be caused by sudden
to the fuel side full open position.
MIX mode is selected, the throttle
curve setting becomes the master.
UNMIX
becomes the master.
call the setup screen shown below.
This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture
control carburetor.
*The needle channel is assigned to CH9 as a default.
(For a description of the setting method, see the description at the
back of this manual.)
To Next Page
Loading...
Need help?
General
