29
<Before Use>
Rubber
grommet
Brass eyelet
Wood screw
Servo mount
2.3-2.6mm nut
washer
Rubber
grommet
Brass eyelet
Servo mount
2.3-2.6mm screw
(Helicopter)(Airplane/Glider)
Servo lead wires
To prevent the servo lead cable from being
broken by vibration during flight, provide a
little slack in the cable and fasten it at suitable
points. Periodically check the cable during daily
maintenance.
Fasten about 5-10cm
from the servo outlet so
that the lead wire is neat.
Margin in the lead wire.
Mounting the power switch
When mounting a power switch to an airframe,
make a rectangular hole that is a little larger than
the total stroke of the switch so that you can turn
Avoid mounting the switch where it can be
covered by engine oil and dust. In general, it is
recommended to mount the power switch on the
Safety precautions when you install
receiver and servos
Warning
Connecting connectors
Be sure to insert the connector until it stops at
the deepest point.
How to protect the receiver from vibration and
water
Wrap the receiver with something soft such
as foam rubber to avoid vibration. If there is
a chance of getting wet, put the receiver in a
waterproof bag or balloon to avoid water.
Receiver's antenna
the receiver's antenna with the cables for
servos.
Locate the receiver's antenna as far as possible
from metals or carbon fiber components such
as frames, cables, etc.
*Cutting or binding the receiver's antenna will reduce the ra
dio reception sensitivity and range, and may cause a crash.
Servo throw
bind or sag when operating the servos to the
full extent.
*If excessive force is continuously applied to a servo, the
servo could be damaged due to force on the gear train and/
or power consumption causing rapid battery drain.
Mounting servos
grommet) under a servo when mounting the
servo on a servo mount. And be sure that the
servo cases do not touch directly to the metal
parts such as servo mount.
*If the servo case contacts the airframe directly, vibration
will travel to and possibly damage the servo.
Mounting the Servo
To Next Page
Loading...
Need help?
General
