77
<Linkage Menu>
System Type selection
changed from among 5 choices: FASSTest 18CH,
S-FHSS. Select the system matched to the type of
receiver you are using.u
*Even if it changes a System Type, other model data is not
reset.e
*If a system type is changed in the case of a helicopter, It
can choose out of two channel orders.
[Yes] : Selection sets the channel order suitable for System
Type. (We recommend here. )
[No] : The present channel order is maintained.
*After change should operate a model and should fully
check a direction and a motion.
Receiver linking
The receiver will only be controlled (without being
affected by other transmitters) by the transmitter it
is linked to. When using a receiver other than one
purchased as a set, linking is necessary.
Dual receiver function (only FASSTest 18CH
mode)
Dual receivers can be linked with the T18MZ.
Two receivers are recognized individually by ID
"1-8CH", and setting the second as "9-16CH", two
sets of receivers can be used as a set in the model,
allowing you 16 channels. If a Dual receiver
function is used, the following function can set up
individually.
・
・
Telemetry function
・
Sensor setup
System Type
Telemetry function (FASSTest mode only)
To use the telemetry function, set “Telemetry” to
“ON”.
D/L Interval (FASSTest mode only)
When a telemetry function is enabled, the receiving
interval (down-link interval) of sensor data can be
changed.
the sensor data display becomes slower, but stick
response will improve.
Battery fail-safe voltage setup (only FASSTest
mode)
The voltage which battery fail-safe activates, can
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
To Next Page
Loading...
Need help?
General
