To Next Page

To Previous Page

S.BUS Installation

This set uses the S.BUS system. The wiring is as simplified and clean mounting as possible, even with

models that use a large number of servos. In addition, the wings can be quickly installed to the fuselage

without any erroneous wiring by the use of only one simple wire, even when there are a large number of servos

used.





T18MZ)



Receiver:R7008SB

Battery:FR2F1800(Optional)

Switch:HSW-L

Throttleservo:S9070SB(Optional)

Aileronservo:BLS174HV×2(Optional)

Elevatorservo:BLS171HV×2(Optional)

RudderServo:BLS175HV×1(Optional)

HAB×3(Optional)



Receiver:R7008SB

Servo:S3171SB×9(Optional)

HUB×4(Optional)

S.BUS GliderUsageexample

S.BUSAerobaticplaneUsageexample

FUTABA T18MZ User Manual

Other manuals for FUTABA T18MZ