56
<System Menu>
Range Check
The 'range check mode' reduces the transmission
range of the radio waves to allow for a ground
range check.
*The range check mode, when activated, will continue for90
seconds unless the user exits this mode early. When the
progress bar reaches 90 second mark, the RF transmission
automatically
returns to the normal operating power.
→
→
[
[
Warning
Do not fly in the range check mode.
*Since the range of the radio waves is short, if the
model is too far from the transmitter, control will
be lost and the model will crash.
Rotation Range Check method
→
*For safety, the RANGE CHECK mode can not be selected
while the RF transmission is active.
*When the [RESTART] botton is pressed, the range check
mode timer is returned to 0.
*Please note, upon expiration of the 90 seconds, or when [Exit]
is selected, the transmitter will automatically return to the
normal RF operation as noted on the display.
*Once the 18MZ is transmitting at full power, it is not
possible to enter the Range Check mode without first
switching the transmitter Off and back On. This has been
designed to prevent a modeler from inadvertently flying in
the Range Check mode.
*After exiting the Range Check mode, the function cannot be
selected again. To select the Range Check mode again you
must cycle the transmitter power switch.
To Next Page
Loading...
Need help?
General
