85
<Linkage Menu>
End Point (ATV)
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
The Travel rate(normal full stick movement at
each direction on channels 1 to 16. Also, the Limit
involved) where servo throw stops may be varied
Servo travel adjustment
Limit point adjustment
Note: The indicators on the screen display actual servo throw
of the each channel. The center position of the indicator is
based on the Sub-Trim settings. Therefore the Sub-Trim
adjustment changes the Limit point display of the indicator.
The Servo Speed setting is used to set the servo delay for
each channel, from channel l to channel 16. The system uses
the programmed speed (delay) to slow down servo position
in each channel.
Servo speed setting
To Next Page
Loading...
Need help?
General
