GE LOGIQ C9 Series User Manual

General Procedures and Functional Checks
4-24 LOGIQ C9 Series – Basic Service Manual
5482298-100 English Rev. 5
Probe/Connectors Check
NOTE: Probes can be connected at any time, whether the unit is ON or
OFF.
To connect a Probe
1. Place the probe’s carrying case on a stable surface and
open the case.
2. Carefully remove the probe and unwrap the probe cable.
3. DO NOT allow the probe head to hang free. Impact to the
probe head could result in irreparable damage.
4. Turn the connector locking handle counterclockwise.
5. Align the connector with the probe port and carefully push
into place.
6. Turn the connector locking hadle clockwise to secure the
probe connector.
7. Carefully position the probe cable in the probe cord holder
spot so it is free to move, but not resting on the floor.
CAUTION
TAKE THE FOLLOWING PRECAUTIONS WITH THE PROBE
CABELS:
-KEEP AWAY FROM THE WHEELS
-DO NOT BEND
-DO NOT CROSS CABLES BETWEEN PROBES
Table 4-1: Probe and Connectors Checks
Step Task Expected Results
1 Select the appropriate connected probe from the
probe indicators on the Touch Panel.
The probe activates in the currently-selected
operating mode. The probe’s default
settings for the mode and selected exam are
used automatically.
2 Lauch the application. To change application without
changing the current probe, press Model on the
Touch Panel.
The selected application starts.
3 Verify there’s no EMI/RFI or artifacts specific to the
probe.
No EMI/RFI or artifacts.
4 Test the probe in each active connector slot. It will display pictorial data each time.
5 Do a leakage test on the probe, See ‘Electrical
safety tests’ on page 10-19 for more information.
It passes the test.
6 Repeat this procedure for all available probes.

GE LOGIQ C9 Series Specifications

General

Brand	GE
Model	LOGIQ C9 Series
Category	Medical Equipment
Language	English