DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 1 Introduction 1 - 5
1-2-5 Product description
Overview of the LOGIQ E10
The LOGIQ E10 is a high performance digital ultrasound imaging system with total data management.
The fully digital architecture of the LOGIQ E10 allows optimal usage of all scanning modes and probe
types throughout the full spectrum of operating frequencies.
Signal flows from the Probe Connector Panel through the Ultrasound system and finally to the monitor
and peripherals.
System configuration is stored on the hard drive.
All necessary software is loaded from the hard drive on power up.
For more information on:
• Installed software versions, see "Software Status" on page 7-17
• Installed hardware, see Section 7-3 "Service desktop" on page 7-10
• Connected probes, see Section 7-3 "Service desktop" on page 7-10
• Compatible software, hardware, peripherals, and probes, see "Software" on page 9-4
Purpose of the user manual
The user manual should be fully read and understood before operating the LOGIQ E10.
The online versions of the user manual is available through the Help function on the LOGIQ E10’s
operator panel.
User manual documentation is provided through electronic Instructions for Use (eIFU).
To Next Page
Loading...
Need help?
General
