To Next Page

To Previous Page

Care and Maintenance

10-8 LOGIQ V2/LOGIQ V1 – Basic Service Manual

5610739-100 English Rev.10

Tools required

NOTE: For a list of required tools for servicing the LOGIQ V2/LOGIQ

V1, refer to chapter 8.

Standard GE tool kit

The following is a description of the “Standard” GE tool kit in the

USA. Not all tools are required.

Table 10-2: Overview of GE-1 tool kit contents

Tool ID Description Tool ID Description

9-45358 Pliers Retaining Ring 9-XL9971MM Xcelite-hex Blade 1.27mm

9-4078 Scribe 9-XL9972MM Xcelite-hex Blade 1.5mm

9-44572 Wrench Open End 3/8 - 7/16 9-XL9973MM Xcelite-hex Blade 2 mm

9-44579 Wrench Open End 1/2 - 9/16 9-XL9974MM Xcelite-hex Blade 2.5mm

9-44579 Wrench Open End 1/2 - 9/16 9-XL9975MM Xcelite-hex Blade 3mm

9-45385 Pliers, Arc Joint 7 inch 9-XL9976MM Xcelite-hex Blade 4mm

9-45378 Pliers, Slip Joint 9-XL9977MM Xcelite-hex Blade 5mm

9-4518 Pliers, Long Nose, Miniature 9-XL991CM Handle

9-4518 Pliers, Long Nose, Miniature C2356E Screw starter - Kedman

Quick Wedge

9-44776 Ignition Wrench Set, 10 pc. BLBO Box - 18 Compartment

9-44601 Wrench, Adj., 4 inch DWL4283T Box - 5 Compartment

9-4151 Screwdriver, Blade, Stubby 9-41322 Pickup Tool, Claw type

9-41421 Screwdriver, Blade, Pocket

clip

9-6757 6 pc Needle File Set

9-41594 Screwdriver, Blade 1/8 in. × 4

in.

9-9487 Utility Knife

9-41581 Screwdriver, Blade 3/16 in. × 4

in.

9-45341 Pliers Vice Grip 10 inch

9-39451 20' Steel Tape, locking Spring

load

9-3001 Xacto Pen Knife

GE LOGIQ V2 Service Manual

Other manuals for GE LOGIQ V2