5. Working with Stored Data
DMS 2 Operating Manual Page 163
Step 7:
The notation specified (in this case the probe serial
number) will be stored as part of the file’s header and will
appear on any reports printed or sent to a PC. (refer to Chap-
ter 6 to send a report)
5.3.3 Changing Thickness Measurement Values From
the DR Mode
In the DR Mode, it is possible to change the numerical value
of a thickness reading by adjusting the VALUE listing
located in the RECORD display.
Step 1:
Open the Data Recorder by pushing .
Step 2:
Make sure that the data file you wish to work with is
open, and the file location you wish to modify is accessed using
the File Navigation Mode (Section 5.2).
Step 3:
Activate the RECORD Submenu by selecting it with
or so that it’s highlighted. Selections will appear
across the bottom of the display screen including ITEM and
VALUE.
Step 4:
Press below the selection titled ITEM. You’ll
note that several file characteristics are listed on the display,
including VALUE (Note, this is not the VALUE listed as a
submenu selection. Instead, it’s listed in the center portion of
the display screen).
Step 5:
Press below the selection titled ITEM until VALUE
is highlighted.
Step 6:
Press . This will open a short version (numerical
inputs only) of the Virtual Keyboard. Enter the desired material
thickness and press to return to the DR Mode (see
Section 3.4.2 to work with the Virtual Keyboard).
Step 7:
The thickness value will be set to the numeric value
entered with the Virtual Keyboard.
To Next Page
Loading...
Need help?
General
