GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
3 - 52 Section 3-9 - Options Setup
Section 3-9
Options Setup
3-9-1 Software options
Most of the options for VIVID E9 / VIVID E7 are activated by installing a password (alphanumeric text
string).
• For installation instructions, see: 3-6-5 "Software Options Configuration" on page 3-35.
• For available options, see: Section 9-20 "Options - VIVID E9 / VIVID E7" on page 9-75.
3-9-2 Stereo vision
For descriptions and setup instructions, please refer to ‘Stereo vision’ in chapter 5 in the user manual.
3-9-3 Color Video Printer setup
NOTE: The Color Video Printer is an option.
An external Color Video Printer may be connected to one of the USB ports on VIVID E9 / VIVID E7.
NOTE: SONY UP-D23MD/UP-D25MD and MITSUBISHI CP30DW are medical devices so they can be
placed near the VIVID E9 / VIVID E7. The USB cable is 5 meters long, so it must be placed
within reach of this cable.
3-9-3-1 Preparations for installing the CP30DW for the first time
•Set Switch 1 and 2 on the rear side of the printer to ON.
- Please refer to the documentation for the printer if you need help to locate the switches.
- Please refer to the “Printer Driver Installation Manual”, Direction GA294652, Rev. 4 (or newer)
if you need to install a new printer driver.
3-9-3-2 Generic installation instructions
1.) Connect the USB cable to the printer and to the USB port on VIVID E9 / VIVID E7’s Rear Panel.
2.) Select the correct Power cable and connect it to the printer and to the mains power outlet.
3.) Switch on the power switch on the printer.
To be able to use the printer, the printer must be selected on the VIVID E9 / VIVID E7.
For more information, please refer to the “Printer Driver Installation Manual”,
Direction GA294652, Rev. 4 (or newer).
To Next Page
Loading...
Need help?
General
