27
Operators Manual
3. Remove the B2C coffee chute assembly as
shown. Unscrew the two knurled thumbscrews
and remove the coffee chute and coffee chute
cover.
With a clean, dry brush clean the area around
and under the coffee dispense outlets.
4. With a clean, dry brush wipe away any coffee
deposits from both the coffee chute and cover
mouldings.
Refit the coffee chute lid to the chute ensuring
that the lugs on the cover fit securely into their
mounting holes.
Refit the assembly to the machine and secure
using the two knurled thumbscrews.
5. Carefully remove the brewer waste container
from the machine and empty the contents. Push
up and remove the waste chute (a) from the
machine.
Wash both the waste container and chute
thoroughly and if necessary sanitise using the
diluted bactericidal cleaning solution. Rinse in
clean water.
Dry both components using a clean, dry cloth and refit to the machine.
N.B. If the waste container counter is enabled every time that the
container is emptied the counter must be reset. Restore power to the
machine using the safety key and press button 12 on the service keypad.
Two audible bleeps confirm that the counter has been reset to zero.
6. Refit the CoEx® brewer unit into the machine.
Slide the unit into place until it ‘clicks’ into
position. Refit the coffee dispense pipe to the
brewer outlet as shown.
Ensure that both the fresh bean container and
fresh ground coffee canister are filled with
correct product. Refill if necessary following the
procedures outlined on page 22.
a
To Next Page
Loading...
Need help?
General
