4.8 Tea Pot Brewer Cleaning Procedure
The following procedure must be carried out weekly. Proceed as follows:-
Safety First! Never clean or service the tea pot brewer unit while it is in
motion as fingers may become trapped in the mechanism.
1. Remove the tea outlet pipe from the dispense
head block. Lift and remove the mounting
bracket c/w tea pot bowl from the machine.
Split the assembly into its component parts.
Clean all parts of the tea pot bowl assembly and
mounting bracket using the liquid destaining
agent.
Follow the instructions for soak cleaning on the
product packaging. Rinse all components with clean water and dry
thoroughly.
2. Undo the knurled thumb screw retaining the tea
brewer unit.
Press down on the retaining clip and remove
the complete tea brewer unit from the machine
as shown.
3. Split the brewer unit into its separate parts as
shown. Clean gauze (a), outlet (b) and bowl (c)
using the liquid destaining agent. Follow the
instructions for soak cleaning on the product
packaging.
Rinse all components in clean water, dry
thoroughly, re-assemble and refit to machine.
Secure using the knurled thumb screw.
4. Re-fit tea pot bowl/mounting bracket assembly to the machine. Re-
connect the outlet pipe to the dispense head block.
29
Operators Manual
a
c
b
To Next Page
Loading...
Need help?
General
