31
Operators Manual
b. Press and release the Flush button (3). The flush sequence begins.
c. Empty the waste water container when complete.
5.4 Button 4 - Brewer Clean (Freshbrew Models)
1. The brewer clean button allows the brewer to be cleaned independently.
In order to guarantee the highest standards of cleanliness, the boiler fill
valve is disabled, ensuring that the water used is delivered at the optimum
temperature to kill any micro-organisms.
2. The brewer unit is filled with hot water and then operated through four
complete brew cycles.
3. Once the cleaning cycle is complete, the boiler refills and when the water
is at the correct temperature, the machine returns to standby mode, ready
to vend.
4. To clean the brewer:
a. Open the front door of the machine. Using the clamp
supplied, close the tea outlet tube as shown. Insert the
safety key.
Caution: Ensure that a suitable container is placed
under the dispense position. Keep hands away from
the dispense area whilst the cleaning cycle is in operation.
b. Pour the recommended amount of destaining fluid directly into the
top of both brewer chambers. Remove the clamp from the tea
dispense pipe (see pages 23 & 24).
c. Press and release the Brewer Flush
button (4). The sequence will begin
and the LCD will display the
message as shown.
d. Repeat step ‘c’ until all traces of
the cleaning solution have been
removed from the brewer chambers.
e. Empty the waste water container when complete.
To Next Page
Loading...
Need help?
General
