GWN7000 User Manual
Version 1.0.6.28
Specify the UDP Source port from which the traffic filter rule will be applied.
Specify the UDP Source port to which the traffic filter rule will be applied.
Choose the LAN group of the specified Source IP address. If no Source IP address
has been defined, the rule will be applied to all members of that LAN group.
Define a Name for the Policer rule.
Select an interface from which the traffic will be policed, make sure to enable the
desired interface from General QoS in order to appear.
Set the priority of the traffic class, the lower the value, the highest the priority. Valid
range is between 1 and 64.
Set a Rate value for download bandwidth when applying policer rule.
Choose the Differentiated Services Code Point (DSCP) value from drop-down list.
Default is 0.
Specify the Source IP address from which the policer rule will be applied.
Specify the Destination IP address to which the policer rule will be applied.
Specify the TCP Source port from which the policer rule will be applied.
Specify the TCP Source port to which the policer rule will be applied.
Specify the UDP Source port from which the policer rule will be applied.
Specify the UDP Source port to which the policer rule will be applied.
Choose the LAN group of the specified Source IP address.
If no Source IP address has been defined, the rule will be applied to all members
of that LAN group.
Table 16: QoS Policy Manager (acc)
Define a name for the traffic policy which can be then select on general tab settings
if settings the QoS type for a wan interface to acc (adaptive congestion control).
Upload/Download → Policy Class
Set a name for the traffic class.
Configure the bandwidth share percentage for this class of traffic, the acc
mechanism will dynamically borrow bandwidth from other classes if one class
needs more, thus using efficiently the available bandwidth.