GWN7000 User Manual
Version 1.0.6.28
Allow Forwarding between
Site-To-Site VPNs
This option allows forwarding between multiple site-to-site VPNs. i.e.
if there are multiple PPTP users configured with client subnet
enabled, then this option allows one PPTP client subnet to access
another PPTP client subnet through the server.
Note: for this option to work more than one PPTP users with client
subnet must be enabled.
Enable / disable the MPPE for data encryption. By default, it’s
disabled.
Select which routing policy to assign to the traffic from this VPN
network. See Policy Routing section
Choose to which destination group or WAN to allow traffic from the
VPN, this will generate automatically a forwarding rule under the
menu Firewall → Traffic Rules → Forward.
PPP Keep-Alive Interval (sec)
Interval in seconds for LCP echo-request frames to be sent.
PPP Keep-Alive Failure
Threshold
The PPTP server will consider a peer to be dead if N Echo-request
frames aren’t replied to. The connection will be then terminated.
A setting of 0 disables this function.
If the PPP keepalive failure settings is enabled, then echo-request
frames will only be sent if no traffic has been received from the peers
since the last echo-request was sent.
Enable debug logging to syslog.
Specify the MTU, valid range (1280-1500 Bytes).
Specify the MRU, valid range (1280-1500 Bytes).
2- Click after completing all the fields.
3- Click on top of the web GUI to apply changes.
After this step, you need to create user accounts under web GUI → System Settings → User Manager in
order to connected to the configured PPTP server.
To Next Page
Loading...
Need help?
General
