8
Save These Instructions3-90-775R36_09/15
D. Pre- Use Check List
1. Placetheapplianceinalocationnearthenal
installation and follow the procedures below.
2. Opentheapplianceandremoveallarticles
packedinside. Inspectall itemsforshipping
damage. Notify dealer of any missing or
damaged goods.
3. All safety warnings have been read and
followed precisely.
4. This Owner's Manual has been read in it's
entirety.
5. Floor protection requirements have been
read and followed.
6. The ue connector has been installed in
accordance with the instructions herein.
7. The proper clearances from the appliance
and chimney connector to combustibles have
been met.
8. The masonry chimney has been cleaned and
inspected by a professional, or the factory
built metal chimney is installed according to
the manufacturers instructions.
9. The chimney meets the minimum height
requirements.
10. All labels and hang tags have been removed
from the glass.
11. All plated surfaces have been wiped clean, if
applicable.
12. The room sensor and any additional cable
has been installed properly.
13. A properly grounded electrical receptacle
is available within reach of the unit's power
cord.
14. A good quality surge protector is highly
recommended to protect the electronics.
Fire Risk.
Hearth & Home Technologies
disclaims any responsibility for, and
the warranty will be voided by, the
following actions:
• Installation and use of any damaged appliance.
• Modicationoftheappliance.
• Installation other than as instructed by Hearth &
Home Technologies.
• Installation of substitute materials or replacement
parts not approved by Hearth & Home Technologies
• Operating appliance without fully assembling all
components.
• DoNOTOverre.
Oranysuchactionthatmaycausearehazard.
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
• DoNOTinstalldamagedcomponents.
• DoNOTinstallincompletecomponents.
• DoNOTinstallsubstitutecomponents.
Report damaged parts to dealer.
WARNING
To Next Page
Loading...
Need help?
General
