This device complies with Part 15 of the FCC Rules.
Operation
is
subject
to the
following
two
conditions:
(1)
this device may not cause
harmful interference,
and (2)
this device must accept any interference received,
includ-
ing interference that may cause undesired operation.
Modifications not expressly approved by the radio
manufacturer
could void the
user
’s
authority
to operate
the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed
to
provide reasonable protection against
harm-
ful
interference
in a
residential installation.
This equip-
ment generates, uses and can radiate radio frequency
energy
and, if not
installed
and used in
accordance
with
the
instructions, may cause harmful interference
to radio
communications.
However, there is no guarantee that
interference
will not occur in a
particular
installation.
If this equipment does cause harmful interference to
radio
or
television reception, which can
be
determined
by
turning
the
equipment
off
and
on, the
user
is encouraged
to try to correct the
interference
by one or more of the
following measures: - Increase the separation between
the
equipment
and receiver. - Consult the dealer or an
experienced
radio
technician
for help.
Safety Information
Exposure
to Radio
Frequency
Radiation
The
radiated
output power of the this internal wireless
radio is far below the FCC radio frequency exposure
limits.
Nevertheless,
the
wireless
radio shall be used in
such
a
manner
that the
radio
is 20 cm or
further from
the
human
body.
To Next Page
Loading...
Need help?
General
