Note
The QR code is usually on the back cover of the device.
4.
Oponal: If the QR code fails to be recognized, tap and enter the serial number of the device,
and then select the device type.
Note
The serial number is usually on the back cover of the device.
5. Tap Add.
Note
• When the adding peripheral is a detector, the detector will be linked to the zone. You can
view the detector informaon in the Zone tab.
• Up to 32 detectors can be linked to the zone.
The added peripheral will be listed in the Zone tab or the Peripheral Device tab.
Note
One of the most important factors for a reliable wireless installaon is the signal strength
between a wireless device and the panel. If a device is out of range it will not be able to send
events to the control panel therefore it is recommended that a signal strength test is performed
before
xing devices into place. The control panel has advanced signal strength mechanism that
operates by monitoring all inputs/bells on the web browser. The page will need to be re-freshed
every me for a new test. See also Appearance-Funcon Buon.
When performing a signal strength test it is recommended that the system is tested in the
'worst case scenario'. For example with all doors and windows closed.
4.4.5 Add Card
You can add card to the control panel. Use the card to arm, disarm, or clear alarm.
Steps
1. On the device list page, tap the security control panel and then log in to the device (if required)
to enter the paron page.
AX Security Control Panel
62
To Next Page
Loading...
Need help?
General
