Chapter 5 System Configuration
5.1 Storage Settings
Before you start:
To configure record settings, please make sure that you have the network storage device within
the network or the memory card inserted in your speed dome.
5.1.1 Configuring Recording Schedule
Purpose:
There are two kinds of recording for the speed domes: manual recording and scheduled recording.
In this section, you can follow the instructions to configure the scheduled recording. By default,
the record files of scheduled recording are stored in the memory card (if supported) or in the
network disk.
Steps:
1. Enter the Record Schedule settings interface:
Configuration > Storage > Schedule Settings > Record Schedule
Figure 5-1 Recording Schedule Interface
2. Check the checkbox of Enable to enable scheduled recording.
3. To set the advanced settings of the speed dome, click to enter the advanced
settings interface.
To Next Page
Loading...
Need help?
General
