HIKVISION DS-K1T342 Series User Manual

Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
Steps
Note
The funcon should be supported by the device.
1.
Click Conguraon → Network → Advanced Sengs → Plaorm .
2.
Select ISUP from the plaorm access mode drop-down list.
3.
Check Enable.
4.
Set the ISUP version, and view the alarm receiver type, server address, port, device ID, register
status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5.
Set the ISUP listening parameters, including ISUP alarm center IP address/domain name, ISUP
alarm center URL, and ISUP alarm center port.
6.
Click Save.
Congure HTTP Listening
The device can send alarm informaon to the event alarm IP address or domain name via HTTP
protocol/HTTPS protocol.
Before You Start
The event alarm IP address or domain name should support the HTTP protocol/HTTPS protocol to
receive the alarm informaon.
Note
The funcon should be supported by the device.
Steps
1.
Click Conguraon → Network → Advanced → HTTP Listening .
2.
Edit the event alarm IP address or domain name, URL, port, and protocol.
3.
Oponal: Click Default to reset the event alarm IP address or domain name.
4.
Click Save.
9.5.13 Set Video and Audio Parameters
Set the image quality, resoluon, and the device volume.
DS-K1T342 Series Face Recognion Terminal User Manual
129

HIKVISION DS-K1T342 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T342 Series
Category	Touch terminals
Language	English