To Next Page

To Previous Page

Table 7-2 Access Control Parameters Descripons

Parameter Descripon

Terminal Auth. Mode (Terminal

Authencaon Mode)

Select the face recognion terminal's authencaon mode. You

can also customize the authencaon mode.

Note

●

Only the device with the ngerprint module supports the

ngerprint related funcon.

●

Biometric recognion products are not 100% applicable to

an-spoong environments. If you require a higher security

level, use mulple authencaon modes.

●

If you adopt mulple authencaon modes, you should

authencate other methods before authencang face.

Reader Auth. Mode (Card

Reader Authencaon Mode)

Select the card reader's authencaon mode.

Enable NFC Card Enable the funcon and you can present the NFC card to

authencate.

Enable M1 Card Enable the funcon and you can present the M1 card to

authencate.

Door Contact You can select "Open (Remain Open)" or "Close (Remian

Closed)" according to your actual needs. By default, it is Close

(Remian Closed).

Open Duraon Set the door unlocking duraon. If the door is not opened for

the set me, the door will be locked. Available door locked me

range: 1 to 255s.

Authencaon Interval Set the device authencang interval. Available authencaon

interval range: 0 to 65535.

7.9 Time and Aendance Status Sengs

You can set the aendance mode as check in, check out, break out, break in, overme in, and

overme out according to your actual situaon.

Note

The funcon should be used cooperavely with me and aendance funcon on the client

soware.

DS-K1T342 Series Face Recognion Terminal User Manual

HIKVISION DS-K1T342 Series User Manual

Questions and Answers: