iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 99
Only certain device models support the function.
Set Hard Hat Detection
Before You Start
1. Go to Configuration → System → System Settings → VCA Resources to enable Hard Hat Detection.
Steps
1. Go to Configuration → Hard Hat Detection, and check Enable Hard Hat Detection.
2. Optional: Set Target Generation Speed. It refers to the target generation speed of the face entering the
detection region. The greater the value, the quicker the generation speed.
3. Set detection region.
1) Select detection region.
2) Click Draw Area, and click and draw the endpoints of the region in the live view image.
3) Right click to finish the drawing.
• Click Stop Drawing: Finish drawing the region.
• Click Clear All: Draw the region again.
4. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings, refer
to Linkage Method Settings.
5. Click Save.
Face Comparison and Modeling
For certain device models, you need to enable Multi-Target-Type Detection or Face Capture on VCA
Resource page first.
Face Comparison
Face comparison serves the purpose of face recognition by comparing the captured faces with those in
the face picture library.
Set Face Picture Library
Face picture library is used to store modeled human faces and information.
Steps
1. Go to Configuration → Face Picture Library.
2. Create a face picture library.
1) Click to add a face picture library.
To Next Page
Loading...
Need help?
General
