HIKVISION iDS-9664NXI-I8/16S User Manual

Steps
1. Go to Smart Analysis → Smart Event Sengs → Video Structuralizaon .
2. Select a camera.
3. Check Enable
Mul-Target-Type Detecon.
4.
Oponal: Check Save VCA Picture to save the captured intrusion detecon pictures.
5.
Oponal: Check Enable NVR Smart Analysis. The device will analyze the video, cameras only
transmit video stream.
6. Set detecon area.
1) Click Draw Area.
2) Adjust the red frame on the image to draw the
detecon area. It is full screen by default.
3) Click Stop Drawing.
7.
Oponal: Set Capture Quality. The captured picture will be stored to the device, high quality
brings higher resoluon, but it takes larger storage space. Picture quality will not aect detecon
accuracy.
8. Set the arming schedule. Refer to Congure Arming Schedule .
9. Set the linkage method. Refer to
Congure Linkage Acons .
10. Click Apply.
7.7 Vehicle
Detecon
Vehicle detecon is available for the road trac monitoring. In vehicle detecon, the passed
vehicle can be detected and the picture of its license plate can be captured. You can send alarm
signal to nofy the surveillance center.
7.7.1
Congure Vehicle Detecon
Vehicle detecon, available in the road trac monitoring, is tend to detect the passed vehicle on
the road, and capture its license plate at the same me.
Steps
1. Go to Smart Analysis → Smart Event
Sengs → Vehicle Detecon .
2. Select a camera.
3. Click Vehicle.
4. Check Enable Vehicle
Detecon.
5. Oponal: Check Save VCA Picture to save the captured vehicle detecon pictures.
6.
Congure rules, including Area Sengs, Picture, Overlay Content, and Blocklist and Allowlist.
Area Sengs
Up to 4 lanes are selectable.
Blocklist and Allowlist
You can export the le rst to see its format, and edit it and import it to the device.
7. Click Apply.
Network Video Recorder User Manual
106

HIKVISION iDS-9664NXI-I8/16S Specifications

General

Brand	HIKVISION
Model	iDS-9664NXI-I8/16S
Category	Network Hardware
Language	English