5. Oponal: Check Enable IP Camera Time Sync to synchronize the me of the connected IP
camera automacally. For details, refer to IP Camera Time Sync .
6. Oponal: Check Use Default Port to use the default management port to add the camera. For
SDK service, the default port value is 8000. For enhanced SDK service, the default value is 8443.
Note
The funcon is only available when you use HIKVISION protocol.
7.
Oponal: Check Verify Cercate to verify the camera with cercate. The cercate is a form
of idencaon for the camera that provides more secure camera authencaon. It requires to
import the network camera cercate to the device rst when you use this funcon. For details,
refer to
Import Network Camera Cercate .
Note
The enhanced SDK service is only available when you use HIKVISION protocol.
8. Oponal: Click Search to search other network cameras.
9.
Oponal: Click Connue to Add to add other network cameras.
10. Click Add.
1.4.3 Add Network Camera Through PoE
The PoE interfaces enable the device system to pass electrical power safely, along with data, on
Ethernet cabling to the connected PoE cameras. Supported PoE camera number varies with device
module. If you disable the PoE interface, you can also connect to the online network cameras. And
the PoE interface supports the Plug-and-Play
funcon.
Add PoE Camera
Steps
1. Go to Camera → Camera → PoE
Sengs .
2. Enable or disable long network cable mode by selecng Long Distance or Short Distance.
Long Distance
Long-distance (100 to 300 meters) network transmissions via PoE interface.
Short Distance
Short-distance (< 100 meters) network transmission via PoE interface.
Note
●
The PoE ports are enabled with the short distance mode by default.
●
The bandwidth of IP camera connected to the PoE via long network cable (100 to 300 meters)
cannot exceed 6 MP.
●
The allowed max. long network cable may be less than 300 meters depending on
dierent IP
camera models and cable materials.
Network Video Recorder User Manual
10