8.2 Replenishing the makeup
(1) Overview
●Replenish the makeup in the makeup reservoir within 60 minutes after a makeup Low warning was
generated. If replenishment is not performed, the printer will stop.
●The makeup can be replenished without regard as to whether the IJ printer power is ON or OFF or the
printer’s operating state.
●When the makeup is replenished, the warning is automatically reset.
(2) Operation
Open the maintenance cover, pull the reservoir base forward, and remove the
cap of the makeup reservoir.
1
Remove the cap from the makeup bottle and replenish the ink by pouring it into
the makeup reservoir.
●Be sure that the makeup reservoir ink level does not exceed the MAX line.
2
Close the makeup reservoir cap.
●Tighten the cap securely. The solvent component may evaporate.
3
Return the reservoir base to its original position. 4
Close the maintenance cover. 5
Cap
Close Open
Makeup reservoir
Reservoir base
Maintenance cover
Cap
MAX line
Makeup
Makeup level
MAX line
Makeup bottle
reservoir
Makeup
reservoir
To Next Page
Loading...
Need help?
General
