Hitron CVE-30360 User Manual

20
HITRON CVE-30360 USER’S GUIDE
INTRODUCTION
When you turn on the CVE-30360, the LEDs light up in the following order:
Power
US
DS
Status
The ETH 1~4 LEDs light up as soon as there is activity on the relevant port, the
LINE 1~2 ports light up if your service contract includes voice service (the
number of LEDs that lights up depends on your service plan), USB LED lights
up if your have valid USB connection, and the WIRELESS LED lights up once
the wireless network is ready.
1.4 IP ADDRESS SETUP
Before you log into the CVE-30360’s GUI, your computer’s IP address must be in the
same subnet as the CVE-30360. This allows your computer to communicate with the
CVE-30360.
NOTE: See IP Addresses and Subnets on page 25 for background information.
ETH Off No device is connected to any LAN port.
Blinking A device is connected to a LAN port via a fast
Ethernet link, and is transmitting or receiving data.
On A device is connected to a LAN port via a fast
ethernet link, but is not transmitting or receiving
data.
Status Blinking The CVE-30360’s cable modem is registering with
the service provider.
On The CVE-30360’s cable modem has successfully
registered with the service provider.
US Blinking The CVE-30360 is searching for an upstream
frequency on the CATV connection.
On The CVE-30360 has successfully located and
locked onto an upstream frequency on the CATV
connection.
DS Blinking The CVE-30360 is searching for a downstream
frequency on the CATV connection.
On The CVE-30360 has successfully located and
locked onto a downstream frequency on the CATV
connection.
Power On The CVE-30360 is receiving power.
Off The CVE-30360 is not receiving power.
TABLE 2: LEDs

Hitron CVE-30360 Specifications

General

Brand	Hitron
Model	CVE-30360
Category	Network Router
Language	English