Hitron CVE-30360 User Manual

43
HITRON CVE-30360 USER’S GUIDE
LAN
Click LAN > Switch Setup. The following screen displays.
FIGURE 11: The LAN > Switch Setup Screen
The following table describes the labels in this screen.
3.4 THE DEBUG SCREEN
Use this screen to perform ping and traceroute tests on IP addresses or URLs.
Click LAN > Debug. The following screen displays.
TABLE 11: The LAN > Switch Setup Screen
Port This displays the LAN port number.
Speed This displays the maximum achievable data speed in
megabits per second (MBPS).
Duplex  This displays Full when data can flow inbetween the
CVE-30360 and the connected device in both
directions simultaneously.
 This displays Half when data can flow inbetween the
CVE-30360 and the connected device in only one
direction at a time.
Active  Select a Port’s checkbox to enable communications
between the CVE-30360 and devices connected to
the port.
 Deselect a Port’s checkbox if you do not want to
exchange data between the CVE-30360 and devices
connected to the port.
Apply Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.

Hitron CVE-30360 Specifications

General

Brand	Hitron
Model	CVE-30360
Category	Network Router
Language	English