30
OPERATION
STOPPING THE ENGINE
Emergency Engine Stopping
To stop the engine in an emergency,
pull the emergency stop switch clip
out of the emergency stop switch by
pulling the emergency stop switch
lanyard.
We suggest that you stop the engine
this way occasionally
to verify that
the engine and emergency stop switch
are operating properly.
Normal Engine Stopping
1. Move the throttle grip to the
SLOW position.
After cruising at full throttle, cool
do
wn the engine by idling for a few
minutes before stopping the engine.
2. Push the emergency stop switch
button until
the engine stops.
In the event that the engine does
no
t stop when you push the
emergency stop switch, pull the
emergency stop switch lanyard. If
the engine continues to run, move
the fuel valve lever to the OFF
position and pull the choke knob to
stop the engine.
EMERGENCY STOP SWITCH
EMERGENCY STOP SWITCH CLIP
EMERGENCY
STOP SWITCH
LANYARD
THROTTLE GRIP
SLOW
EMERGENCY STOP SWITCH
PUSH
31ZW66320.book 30 ページ ２０１３年１０月４日 金曜日 午後３時４８分
To Next Page
Loading...
Need help?
General
