57
TRANSPORTING
WITH OUTBOARD MOTOR
INSTALLED ON BOAT
When trailering a boat with the
outboard motor attached, leave the
engine in the normal running
position, if possible, and tighten the
steering friction bolt securely (p. 33).
If there is insufficient road clearance
in the
normal running position, then
tilt the outboard motor and use a
motor support bar, or remove the
outboard motor from the boat. Refer
to the manufacturer’s instructions for
using a motor support bar.
WITH OUTBOARD MOTOR
REMOVED FROM BOAT
Turn the vent knob OFF position and
close the fuel filler cap securely
before transporting the outboard
motor.
Remove the outboard motor from the
boat and
secure the outboard motor in
either the vertical or horizontal
position shown on p. 56.
To carry, hold the outboard motor by
th
e carrying handle, as shown.
Lifting the outboard motor by the
engine cover, or using the
installed outboard motor as a
handle or lever to move the boat,
can damage the outboard motor.
MOTOR SUPPORT BAR
(commercially available)
31ZW66320.book 57 ページ ２０１３年１０月４日 金曜日 午後３時４８分
To Next Page
Loading...
