44
SERVICING YOUR OUTBOARD MOTOR
5. Stand the outboard motor in a
vertical position, and install a new
washer and the oil drain screw
securely.
6. Remove the engine cover.
Improper disposal of engine oil can
be harmful to the environment.
If you change your own oil, please
dispose of the used oil properly.
Put it in a sealed container, and
take it to a recycling center. Do not
discard it in a trash bin, dump it on
the ground, or pour it down a
drain.
7. Remove the oil filler cap and fill
the crankcase with the
recommended oil up to the upper
limit mark on the
oil level
inspection window.
Engine oil refill capacity:
0.26 US qt (0.25 L)
8. Install the oil filler cap and tighten
it securely
.
9. Install the engine cover.
10. Install the outboard on the boat.
Engine Oil Recommendations
Oil is a major factor affecting
performance and service life.
Honda 10W-30 FC-W
®
outboard
motor oil is recommended for general
use.
FC-W
®
is a registered trademark of
the National Marine Manufacturers
Association.
If Honda 10W-30 FC-W oil is not
available
, Honda recommends that
you use API service category SG, SH
or SJ oil. The SAE oil viscosity and
service category are in the API label
on the oil container.
OIL FILLER CAP
OIL FILLER HOLE
31ZW66330.book 44 ページ ２０１４年３月２０日 木曜日 午後３時３９分
To Next Page
Loading...
Need help?
General
