Commissioning of a Redundant System Setup
Part No.: 4417593_Rev09 Ensite Pro to CIU 888 Migration Manual
CIU 888 3 - 17
3.8 Updating the INI files
When the secondary CIU 888 has been commissioned, the next step is
to update the INI files needed for Entis Pro. Refer to section 4 for more
information about updating INI files.
3.9 Restarting Entis Pro and loading the updated INI files in Entis Pro
When the INI files have been updated, the next step is to restart the
Entis Pro system(s) connected to the CIU 888s and then load the
updated INI files in Entis Pro. Refer to the Configuration manual
Entis Pro version 2.70x for Windows 7 (Part No. 4416381) for more
information.
3.10 Sealing the CIU 888s
If the CIU 888s feature the option to be sealed, the next step is to have
them sealed by a representative of the W&M authorities or by a W&M
accredited user. Refer to the CIU 888 Sealing Guide (Part No. 4417595)
for more information.
NOTE: If the CIU 888s do not feature the option to be sealed, the W&M configuration
settings can either be locked or left unlocked.
3.11 Verifying the working of the system setup
The final step in the commissioning procedure is verifying if the
redundant CIU 888 system setup is working properly. See section 2.10
for more information.
To Next Page
Loading...
Need help?
General
