Honeywell XNX User Manual

XNX Universal Transmitter Quick Start Guide
82
13 Informational Messages
Number Description Contents of Data Field
I001 Unused
I002 Force Relay Mode Started Bitpattern for relays. (E.G. 7.0 ==All)
I003 Force Relay Mode Ended. N/A
I004 Force mA Mode Started Force current. (E.G. 20.0)
I005 Force mA Mode Ended N/A
I006 Short-Term Inhibit Started N/A
I007 Short-Term Inhibit Ended N/A
I008 Long-Term Inhibit Started N/A
I009 Long-Term Inhibit Ended N/A
I010 mA Output Recalibrated N/A
I011 Bump Test Started N/A
I012 Bump Test Timed Out N/A
I013 Bump Test Completed Concentration < Al1 Peak concentration observed
I014
Bump Test Completed
Al1 < Concentration < Al2
Peak concentration observed
I015 Bump Test Completed. Al2 < Concentration Peak concentration observed
I016 Zero Calibration Successful N/A
I017 Zero Calibration Failed Error code
I018 Calibrate Span Successful 1 of 2 Percent change in span factor from previous
I019 Calibrate Span Successful 2 of 2 Absolute span factor
I020 Calibrate Span Failed Error code
I021 Calibrate Span Timeout N/A
I022 Password Changed 1,2 or 3 (access level)
I023 Performing Soft Reset N/A
I024 Alarms Congured Latching N/A
I025 Alarms Congured Non-Latching N/A
I026 Alarm Relays Congured Normally Energized N/A
I027
Alarm Relays Congured Normally De-
Energized.
N/A
I028 Fieldbus Address Changed New address (e.g. 15)
I029 Fieldbus Speed Changed New speed (e.g. 19200)
I030 Sensor Type Changed iCurrentCalGlobalID
I031 Gas Selection Changed iCurrentCalGlobalID
I032 Time For Beam Block Fault Changed iBlockFltTime
I033 Time For Fault Detection Changed iOtherFltTime
I034 Level For Low Signal Fault Changed fLowSignalLevel
I035 Invalid Path Length Written fPathLen
I036 Path Length Changed fPathLen

Honeywell XNX Specifications

General

Brand	Honeywell
Model	XNX
Category	Transmitter
Language	English