Honeywell XNX User Manual

XNX Universal Transmitter Quick Start Guide
16
4.3 POD Connections
The illustration in Figure 4 details the connections available on each of the
terminal blocks for each type of personality board.
J1 - Remote HART
®
Connector Only
Personality
Boards
Option
Boards
A
B
C
D
E
F
Figure 4. XNX personality board terminal
block legend
Table A Table B
Board Type Function S1 S2 Board Type Connection Function
EC Personality
4-20mA
Output
Source
 
EC Personalit y
TB1
Power, 4-20mA
mV P ersonality Sink
 
mV P ersonality
Power, 4-20mA,
Sensor
IR Personality Isolated
 
IR Personality
Power, 4-20mA,
IR Power and
Signal
Table C Table D
Board Type Function S3 S4 Board Type Connection Function
IR Personality
IR 4-20mA
Input
Source
 
EC Personalit y J2 EC IS Barrier
Sink
 
IR Personality TB2 Com A and B
Table E Table F
Board Type Connection Function Board Type Connection Function
Relay TB4
Remote Reset
Connector
Relay TB3 Relay Output
Modbus
®
SW5
Bus Loop
Terminators
Modbus
®
TB3 Data Connection
Foundation
Fieldbus
SW5 Simulation Mode
Foundation
Fieldbus
TB3 Data Connection
4.4 4-20mA Output, Common Connections and Power
Setting 4-20mA operation; S1 & S2
The XNX Universal Transmitter allows the user to configure the 4-20mA output
to Sink, Source or Isolated mode operation via two programming switches on the
POD. The table below shows the S1 and S2 setting and corresponding output
configuration.
Output Conguration S1 S2
Source Down Up
Sink Up Down
Isolated Down Down

Honeywell XNX Specifications

General

Brand	Honeywell
Model	XNX
Category	Transmitter
Language	English