RemoleAccess
Remote Access
You can access your messages and many of the message center functions from any
Touch Tone phone.
Remote Password
To use the remote access functions, you will need to use the RemotePassword_The
default remote password is #139#oYou can change lhe numbers, but the 3-digit
password must stad and end wilh #,
Follow these instructions to change the remote password°
1. PressMenu repeatedly until SET UP T._ displays and press Start/Enter,
2. Press 4 I, until Remote Password displays and press Start/Enter.
#139# witl display.
3, Change the numbers as desired and press Start/Enlero
Access the message center
1. Call the HP Fax from a Touch Tone phone,
2. Enter your remote password when the device answers the phone,
You will hear 2 short beeps when the password is accepted.
3o Enter the remote command you want to use, Refer to the table below for a list of
commands_
TIP: You must enter a command within 15 seconds or the HP Fax will disconnect the
line,
4. Press#0 to end the remote session.
NOTE: If you do not enter #0, it may take several minutes for the HP Fax to disconnect
and release the phone line,_
Table 4-1 Remote access commands
i ,, i,,,, i,i i ....... i_
Code FuncEon
#0 Exitsremoteaccess,
#1 Skipsto the previousmessage_
#2 Playsback new messages,,After each messageisplayed, press* to hearthe next
one,,TheHPFax beepstwice at theend of lhe messages,
tf youcall in and lhere are no new messages,it beeps4 limes,
........................................................... i ............................
Digital messagecenter(HP1050 Fax only) 39
To Next Page
Loading...
Need help?
General
