EasyManuals Logo
Home>HP>Switch>2530

HP 2530 User Manual

HP 2530
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
Duplicate sequence numbering for ACEs is not allowed in the same ACL. Entering a duplicate ACE
displays the message: Duplicate sequence number.
Using CIDR notation to enter the IPv6 ACL prefix length
CIDR (classless inter-domain routing) notation is used to specify ACL prefix lengths. The switch
compares the address bits specified by a prefix length for an SA or DA in an ACE with the
corresponding address bits in a packet filtered by the ACE. If the designated bits in the ACE and
in the packet have identical settings, the addresses match. (The examples show bit counts subtracted
from 128 for wildcard remainders.)
Table 16 Examples of CIDR notation for prefix lengths
Meaning
Resulting prefix length defining an
address match
SA or DA used in an ACL with CIDR
notation
The leftmost 64 bits must match. The
remaining 64 bits are wildcards.
2620:0:a03:e1022620:0:a03:e102::/64
The leftmost 80 bits must match. The
remaining 48 bits are wildcards.
2620:0:a03:e102:2152620:0:a03:e102:215::/80
All 128 bits must match. This
specifies a single host address.
2620:0:a03:e102:215:60ff:fe7a:adc02620:0:a03:e102:215:60ff:fe7a:adc0/128
The leftmost 112 bits must match.
The remaining 16 bits are
wildcards.
2001:db8:a03:e102:0:ab4:1002001:db8:a03:e102:0:ab4:100::/112
Configuration commands
Configuring ACLs
PageExampleTask
81HP Switch(config)# ipv6 access-list <name-str>Creating, entering and configuring
an ACL
HP Switch(config-ipv6-acl)# <deny | permit>
<ipv6 | esp | ah | sctp | ipv6-protocol-nbr>
<any | host <SA> | SA/<prefix-length>>
<any | host <DA> | DA/<prefix-length>>
<tcp | udp>
<any | host <SA> | SA/<prefix-length>>
[ comparison-operator <value> ]
<any | host <DA> | DA/<prefix-length>>
[ comparison-operator <value> ]
[established]
1
[ack] [fin] [rst] [syn]
2
<icmp>
<any | host <SA> | SA/<prefix-length>>
<any | host <DA> | DA/<prefix-length>>
[log]
3
88HP Switch(config)# ipv6 access-list <name-str>
HP Switch(config-ipv6-acl)# <seq-#> < deny | permit >
Inserting an ACE in an existing ACL
with a sequence number
80 Updates for the HP Switch Software IPv6 Configuration Guide

Table of Contents

Other manuals for HP 2530

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 2530 and is the answer not in the manual?

HP 2530 Specifications

General IconGeneral
BrandHP
Model2530
CategorySwitch
LanguageEnglish

Related product manuals