Example 40 Summary table of access lists
HP Switch(config)# show access-list
Access Control Lists
Type Appl Name
----- ---- ------------------------
ext yes 101
1
std yes 55
2
ext yes Marketing
3
ipv6 no Accounting
4
ipv6 no List-01-Inbound
5
ipv6 yes List-02-Outbound
ipv6 yes Test-1
4
5
1
1
1
These ACLs exist in the configuration but are
not applied to any interfaces and thus do not
affect traffic.
IPv4
MeaningTerm
Show whether the listed ACL is an IPv6 (ipv6) ACL or one of two IPv4 ACL types:Type
• std (Standard; source-address only)
• ext (Extended; protocol, source, and destination data)
Show whether the listed ACL has been applied to an interface (yes/no).Appl
Show the identifier assigned to each ACL configured in the switch.Name
Displaying content of all ACLs on the switch
The show access-list command provides configuration details for every ACL configured in
the running-config file, whether or not you have assigned any to filter traffic on switch interfaces.
Syntax:
show access-list config
List the configured syntax for all ACLs currently configured on the switch.
NOTE: You can use the output from this command for input to an offline text file where you can
edit, add, or delete ACL commands. See “Creating or editing an ACL offline” (page 102).
This information also appears in the show running display. If you execute write memory after
configuring an ACL, it appears in the show config output.
For example, with two ACLs configured in the switch, you will see results similar to the
followingExample 41 “An ACL configured syntax listing”:
96 Updates for the HP Switch Software IPv6 Configuration Guide
To Next Page
Loading...
Need help?
General
