To Next Page

To Previous Page

1-15

Introducing the HP 5400R zl2 Switches

Front of the Switch

Introducing the HP 5400R zl2

Switches

For 10/100/1000BASE-T, SFP and SFP+ Ports:

• Off = 10 Mbps or 100 Mbps

• Flashing = 1 Gbps

• On = >1Gbps

For HP Smart Rate ports:

•Off = Not linked

• Slow Flash = 1 Gbps

• Double Flash = 2.5 Gbps

• Triple Flash = 5 Gbps

• On = 10 Gbps

For QSFP+ ports:

•Off = Not linked

• Fast Flash = 40 Gbps

For more information on HP Smart Rate port LEDs and 40G ports in speed

mode, see HP Switch v3 zl2 module installation guide.

■ If the PoE indicator LED is lit, the Link and Mode LEDs indicate PoE

status:

Link LED:

• On = PoE is enabled on this port

• Off = PoE is disabled on this port.

• Slow Blinking Orange = Internal PoE fault on this port.

• Fast Blinking Orange = This port is denied PoE power or has an

external load fault.

Mode LED:

• On = PoE power is be supplied on this port

• Off = PoE is not being supplied on this port.

Console Port

There are two console ports on the switch. These ports are used to connect a

console to the switch. The one port uses the serial cable supplied with the

switch and the other port uses a MicroUSB cable which is not supplied with

the switch. This connection is described under “Connecting a Console to the

Switch” in chapter 2, “Installing the 5400R zl2 Switches”. The console is a full-

featured interface that can be used to configure, monitor, and troubleshoot

the switch. It can be run on a PC, laptop, or handheld device emulating a VT-

100 terminal, or on a standard VT-100 terminal.

PoE

HP 5400R zl2 Series User Manual

Questions and Answers: