2-27
Installing the HP 5400R zl2 Switches
Hot Swapping Switch Modules
Installing the HP 5400R zl2
Switches
2. Start the telnet program and connect to the switch’s IP address.
3. The copyright page and the message “Press any key to continue” will
display. Press a key, and the switch console CLI prompt will display.
If you want to continue with console management of the switch at this time
through either a direct connection or a TELNET session, see chapter 3,
“Getting Started With Switch Configuration” for some basic configuration
steps. For more detailed information, refer to the Management and Config
-
uration Guide which is on the HP networking Web site.
Out-of-Band Management (OOBM) Port
This RJ-45 port is used to connect a dedicated management network to the
switch.
To use: connect an RJ-45 network cable to the Management port to manage
an HP 5400R zl2 Switch through Telnet from a remote PC or a UNIX worksta
-
tion.
To use this port, the switch must have an IP address. IP settings can be
configured through a Console port connection or automatically from a DHCP/
Bootp server.
A networked out-of-band connection through the Management port allows
you to manage data network switches from a physically and logically separate
management network.
For more information, see the "Network Out-of-Band Management (OOBM)"
appendix in the Management and Configuration Guide at: www.hp.com/
networking/support.
Hot Swapping Switch Modules
The switch modules can be “hot swapped” (except for the Management
Module, it is not hot swappable), that is installed or replaced while the switch
is powered on (See Module Installation Notes on
page 2-8). The procedures
differ slightly, though between adding new modules to an empty slot or
replacing modules with the same type, and exchanging the module with a
different type.
To Next Page
Loading...
Need help?
General