1. At the UEFI shell, use the drivers command.
2. Find the SAS Host Bus Adapter in the list of drivers, and make a note of the Driver ID from
the left column.
3. Use the drvcfg command.
4. Find the SAS Host Bus Adapter’s Driver ID in the list, and make a note of the corresponding
Ctrl ID.
NOTE: If the drivers listing shows X under CFG and DIAG, the drive is in RAID mode and
you can run drvcfg against it.
If the drivers listing shows - under CFG and DIAG, the drive is in HBA mode.
Configuring RAID volumes using the ORCA menu-driven interface
NOTE: The function keys cannot be used in ORCA if you are using a serial console. Substitute
ESC followed by the corresponding number key. For example, F3 would be Esc-3
NOTE: ORCA will not launch if there is no hard disk drive in the server blade.
From the UEFI Shell, enter drvcfg -s <Driver ID> <Ctrl ID>. To locate this information,
see “Determining the Driver ID and CTRL ID” (page 134).
The ORCA main menu will appear.
Configuring RAID volumes using the ORCA menu-driven interface 135
To Next Page
Loading...
Need help?
General