5
P700m controller board
3
11.5 inch (29.2 cm) battery
cable
1
BBWC battery
2 6
Battery mounting bracket Mezzanine card blank
4
512 cache module
IMPORTANT: This product uses the 452348-B21 battery kit, also called the HP SA P-Series Low
Profile Battery. Do not order or use the 383280-B21 battery kit option.
Battery mounting bracket parts
The BBWC battery mounts on a black metal battery mounting bracket installed inside the server
blade. The mounting bracket clips onto a mezzanine card in slot 1. If no card is used in slot 1,
the mezzanine card blank option must be installed for the bracket to clip on.
For installing the bracket on to the server blade, the mounting bracket has:
• A mezzanine post loop that slides over the abutting mezzanine 2 post
• A thumbscrew clip that clips over the mezzanine 1 card or mezzanine blank thumbscrew
located at the rear of the blade
• A mezzanine foot that clips over the edge of the mezzanine 1 card or mezzanine blank that
is installed closest to the center of the blade
For installing the BBWC battery onto the bracket, the mounting bracket has:
• A C-hook to restrain the battery cable
• Two battery restraining clips to restrain the BBWC battery
54 Optional components
To Next Page
Loading...
Need help?
General