HP Integrity rx8640 Deployment Guide

Controller, or HBA_WW_ID option are assumed to belong to the HBA being defined. These
options can be specified in any order, but an option from another category of options cannot
occur between any two options from this category.
Automatic script file format
The automatic script is used to apply automatic configuration rules to unconfigured or configured
controllers. If the -i-with-reset or –reset command line switch is used, the existing controller
configuration is cleared with data loss before the new configuration is applied, effectively making
it an unconfigured controller. The cpqacuxe utility automatic scripting uses the same
configuration suggester that is used in the Express path of the cpqacuxe utility GUI. Therefore,
the automatic configuration rules are the same as the cpqacuxe utility GUI Express path.
The following is an automatic script file syntax:
Action = Configure|Reconfigure
Method = Auto
; Controller Options
; There can be multiple controller specifications in the file
Controller = All | First | Slot [N][:N] |
SerialNumber [N]| WWN [N] |
IOCabinet [N],IOBay [N],IOChassis [N],
Slot [N],Cabinet [N],Cell [N]
ClearConfigurationWithDataLoss = Yes|No
LicenseKey = XXXXX-XXXXX-XXXXX-XXXXX-XXXXX
DeleteLicenseKey = XXXXX-XXXXX-XXXXX-XXXXX-XXXXX
RaidArrayId = “XXXXXXXXXXXXXXXXXXXX”
ReadCache = 0|10|20|25|30|40|50|60|70|75|80|90|100
WriteCache = 0|10|20|25|30|40|50|60|70|75|80|90|100
RebuildPriority = Low|Medium|High
ExpandPriority = Low|Medium|High
SurfaceScanDelay= N
OnlineSpare = Yes|No
RAID = 0|1|4|5|6|ADG
Table 5-6 Automatic script file options
ValueOption
Defines if you are changing existing arrays and logical drives or adding new
ones. This option is required.
Configure: Existing arrays are not modified. If unassigned physical drives exist,
new arrays and logical drives are automatically created.
Reconfigure: Existing arrays might be modified in a non-data-destructive
manner. If unassigned physical drives exist, existing arrays might automatically
be expanded and new arrays automatically created. New logical drives are created
on the expanded and newly created arrays.
If the -i-with-reset or -reset command line switch is used, the existing
controller configuration is cleared with data loss as the first step in the
configurations process, regardless of the setting of the Action mode.
Action
Defines whether you are in Automatic or Custom mode.
Auto is the default value.
Method
70 Utilities Reference

HP Integrity rx8640 Specifications

General

Brand	HP
Model	Integrity rx8640
Category	Server
Language	English