EasyManuals Logo
Home>HP>Switch>J8698A

HP J8698A User Manual

HP J8698A
778 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
2-46
Configuring Username and Password Security
Password Recovery
5. Do one of the following after the “CAUTION” message appears:
If you want to complete the command, press
[Y] (for “Yes”).
If you want to abort the command, press
[N] (for “No”)
Figure 2-23 shows an example of disabling the password-recovery parameter.
Figure 2-23. Example of the Steps for Disabling Password-Recovery
Password Recovery Process
If you have lost the switch’s manager username/password, but password-
recovery is enabled, then you can use the Password Recovery Process to gain
management access to the switch with an alternate password supplied by HP.
Note If you have disabled password-recovery, which locks out the ability to recover a
manager username/password pair on the switch, then the only way to recover
from a lost manager username/password pair is to use the Reset+Clear button
combination described under “Restoring the Factory Default Configuration”
on page 2-36. This can disrupt network operation and make it necessary to
temporarily disconnect the switch from the network to prevent unauthorized
access and other problems while it is being reconfigured.
To use the password-recovery option to recover a lost password:
1. Note the switch’s base MAC address. It is shown on the label located on
the upper right front corner of the switch.
2. Contact your HP Customer Care Center for further assistance. Using the
switch’s MAC address, the HP Customer Care Center will generate and
provide a “one-time use” alternate password you can use with the to gain
management access to the switch. Once you gain access, you can config-
ure a new, known password.
HP Switch(config)# no front—panel—security password—recovery
**** CAUTION ****
Disabling the clear button without password recovery prevents switch passwords
from being reset. If the switch password is lost, restoring the default factory
configuration will be required to regain access!
Continue with disabling password recovery [y/n]? y
HP Switch(config)# _

Table of Contents

Other manuals for HP J8698A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP J8698A and is the answer not in the manual?

HP J8698A Specifications

General IconGeneral
BrandHP
ModelJ8698A
CategorySwitch
LanguageEnglish

Related product manuals